View Full Version : rollcage inspection holes
jeremiahkellam
01-29-2009, 01:34 PM
are they still required?
if so, just so I'm clear, I would need a hole on the main hoop, rear braces, door bars, and a pillar bars??
mitchntx
01-29-2009, 01:57 PM
are they still required?
if so, just so I'm clear, I would need a hole on the main hoop, rear braces, door bars, and a pillar bars??
Drill them if you need to
Adam Ginsberg
01-29-2009, 04:25 PM
Mitch is spot on - only drill them when asked by an official. Let them point out where they need to be drilled.
jeremiahkellam
01-29-2009, 04:56 PM
thanks
mitchntx
01-29-2009, 05:06 PM
For you Mustang owners, use an Oxy-Acetylene torch instead of a drill bit.
Waco Racer
01-30-2009, 08:55 AM
FYI - If there's a line in Tech, you will be asked to leave to drill the holes. You will have to go to the back of the line. Best advice is to get with an official prior to getting in line.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.